Volevo un aiuto sulla configurazione di questa benedetta scheda wireless:
- Codice: Seleziona tutto
00:09.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
Ho seguito le varie guide postate sull'argomento, solo che ancora non riesco a venirne a capo.
La Scheda viene riconosciuta dal sistema:
- Codice: Seleziona tutto
eth1 IEEE 802.11g ESSID:off/any
Mode:Managed Frequency:2.462 GHz Access Point: Not-Associated
Bit Rate=54 Mb/s Tx-Power:25 dBm
RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
La chiave che ho applicato e' una wpa-psk. (ho anche segiuto le istruzioni su come applicarla:(/etc/network/interfaces)::
- Codice: Seleziona tutto
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet dhcp
auto eth2
iface eth2 inet dhcp
auto ath0
iface ath0 inet dhcp
auto wlan0
auto eth1
iface eth1 inet dhcp
pre-up wpa_supplicant -Bw -Dwext -ieth1 -c/etc/wpa_supplicant.conf
post-down killall -q wpa_supplicant
e' giusto??? inoltre lanciando un iwlist eth1 scanning:
- Codice: Seleziona tutto
eth1 Scan completed :
Cell 01 - Address: 00:18:4D:AF:A3:CA
ESSID:"Casabibrigan"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.462 GHz (Channel 11)
Quality:10/100 Signal level:-89 dBm Noise level:-96 dBm
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
36 Mb/s; 48 Mb/s; 54 Mb/s
Extra:bcn_int=100
Extra:atim=0
Cell 02 - Address: 00:17:C2:71:AE:C3
ESSID:"Alice-60642638"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.412 GHz (Channel 1)
Quality:48/100 Signal level:-65 dBm Noise level:-96 dBm
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s
24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s
12 Mb/s; 48 Mb/s
Extra:bcn_int=100
Extra:atim=0
IE: WPA Version 1
Group Cipher : TKIP
Pairwise Ciphers (1) : TKIP
Authentication Suites (1) : PSK
Cell 03 - Address: 00:17:C2:70:6B:D8
ESSID:"Alice-60634446"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.412 GHz (Channel 1)
Quality:31/100 Signal level:-76 dBm Noise level:-96 dBm
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s
24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s
12 Mb/s; 48 Mb/s
Extra:bcn_int=100
Extra:atim=0
IE: WPA Version 1
Group Cipher : TKIP
Pairwise Ciphers (1) : TKIP
Authentication Suites (1) : PSK
Cell 04 - Address: 00:19:5B:23:CB:7C
ESSID:"ZARKUS"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.437 GHz (Channel 6)
Quality:79/100 Signal level:-45 dBm Noise level:-96 dBm
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
36 Mb/s; 48 Mb/s; 54 Mb/s
Extra:bcn_int=200
Extra:atim=0
IE: WPA Version 1
Group Cipher : TKIP
Pairwise Ciphers (1) : TKIP
Authentication Suites (1) : PSK
Cell 05 - Address: 00:13:49:78:B8:4C
ESSID:"ZyXEL"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.437 GHz (Channel 6)
Quality:18/100 Signal level:-84 dBm Noise level:-96 dBm
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
36 Mb/s; 48 Mb/s; 54 Mb/s
Extra:bcn_int=100
Extra:atim=0
di cui la Cell04 e' la mia!
E questo il file wpa_supplicant.conf sotto /etc
- Codice: Seleziona tutto
ctrl_interface=/var/run/wpa_supplicant
network={
ssid=”mio ssid”
psk=”mia chiave”
key_mgmt=WPA-PSK
proto=WPA
pairwise=TKIP
}
Pertanto volevo chiedervi: come faccio ad impostarla in modo tale da poterla usare?? GRAZIE MILLE!!
- Codice: Seleziona tutto
