aircrack , problemi
Inviato: lunedì 12 gennaio 2009, 1:47
ciao a tutti , spero di aver azzeccato la sezione dove postare questa domanda, ho una connessione con protezione wpa e ho già testato la sicurezza della pass con BT3 (backtrack3) , ho visto comuqnue che anche su ubuntu è possibile usare il kit aircrack, ma ho questo "problema" che non riesco a risolvere.
ovviamente con la bt3 fila tutto liscio, sapreste aiutarmi a decifrare l'errore?
SALUTI
Codice: Seleziona tutto
jacer@jacer-laptop:~$ sudo airmon-ng start wlan0
Found 2 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!
-e PID Name
5383 NetworkManager
5387 wpa_supplicant
Interface Chipset Driver
wlan1 Unknown ndiswrapper
wlan0 ZyDAS 1211 zd1211rw - [phy3]
(monitor mode enabled on mon0)
jacer@jacer-laptop:~$ sudo airodump-ng wlan0
ioctl(SIOCSIWMODE) failed: Device or resource busy
ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start wlan0 <#>'
Sysfs injection support was not found either.
jacer@jacer-laptop:~$
SALUTI