[Wireless] connessione NO con WPA

[fulmine]

ciao
faccio tutto come nel wiki del punto 2d della guida ma

ak@ak-laptop:~$ sudo wpa_supplicant -Dwext -iwlan0 -c /etc/wpa_supplicant.conf -dd -B
Initializing interface 'wlan0' conf '/etc/wpa_supplicant.conf' driver 'wext' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
Line: 1 - start of a new network block
ssid - hexdump_ascii(len=7):
    4e 45 54 47 45 41 52                              NETGEAR       
PSK (ASCII passphrase) - hexdump_ascii(len=8): [REMOVED]
key_mgmt: 0x2
proto: 0x1
pairwise: 0x18
PSK (from passphrase) - hexdump(len=32): [REMOVED]
Priority group 0
  id=0 ssid='NETGEAR'
Initializing interface (2) 'wlan0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
ioctl[SIOCSIWPMKSA]: No such device
ioctl[SIOCSIWMODE]: No such device
Could not configure driver to use managed mode
ioctl[SIOCGIFFLAGS]: No such device
Could not set interface 'wlan0' UP
ioctl[SIOCGIWRANGE]: No such device
WEXT: Operstate: linkmode=1, operstate=5
ioctl[SIOCGIFINDEX]: No such device
Failed to add interface wlan0
State: DISCONNECTED -> DISCONNECTED
Segmentation fault (core dumped)
ak@ak-laptop:~$

>:(

lamia interfaccia non é wlan0 ma eth1
potete aiutarmi???

[poomerang]

beh allora sarà il caso che al posto di wlan0 tu metta eth1 :P come minimo

[fulmine]

>:( >:( >:( >:(infatti ovvio!

[poomerang]

eheheh non ti preoccupare, succede spesso di sbagliare e incartarsi per delle banali sviste
adesso funziona tutto?

[fulmine]

si grazie!