ho un problema seccante con il wireless, ho anche provato a cercare nel forum, ma non ho trovato nulla a riguardo..
questa è la mia situazione:
Codice: Seleziona tutto
#lspci
....
05:00.0 Network controller: Intel Corporation PRO/Wireless 3945ABG Network Connection (rev 02)
.....
dio@pampero:~$iwconfig
....
eth1 IEEE 802.11g ESSID:"***"
Mode:Managed Frequency:2.437 GHz Access Point: 00:0D:54:F9:59:62
Bit Rate:54 Mb/s Tx-Power:15 dBm
Retry limit:15 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=91/100 Signal level=-38 dBm Noise level=-39 dBm
Rx invalid nwid:0 Rx invalid crypt:3 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:59 Missed beacon:0
.....
dio@pampero:~$less /etc/wpa_supplicant.conf
network={
ssid="***"
# scan_ssid=1 # only needed if your access point uses a hidden ssid
proto=WPA
key_mgmt=WPA-PSK
psk="*******"
}
dio@pampero:~$ ifconfig
...
eth1 Link encap:Ethernet HWaddr 00:18:DE:55:57:72
inet addr:10.0.0.99 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: fe80::218:deff:fe55:5772/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:81801 errors:3 dropped:66 overruns:0 frame:0
TX packets:40192 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:86396401 (82.3 MiB) TX bytes:4024614 (3.8 MiB)
Interrupt:193 Base address:0x4000 Memory:d2100000-d2100fff
...
Codice: Seleziona tutto
dio@pampero:~$less /etc/network/interfaces
.....
auto eth1
iface eth1 inet static
address 10.0.0.99
netmask 255.255.255.0
gateway 10.0.0.1
wireless-essid ****
wireless-key s:********
wpa-driver wext
wpa-conf /etc/wpa_supplicant.conf
.....
il bitrate dichiarato è 54Mb/s
ma in realtà la rete va molto più lenta, sull'ordine dei 2Mb/s. :-\
il link quality è ottimo, uso il channel 6.
qualche consiglio? ???
ciao, complimenti a tutti e grazie!

