problema audio toshiba satellite P100-105
Inviato: lunedì 10 marzo 2014, 0:34
Ho da pochissimo installato Ubuntu 13.10 su questo PC, ma non riesco a fare riprodurre i suoni, come faccio, qualcuno ha avuto mai questo problema?
Il forum della comunità italiana di Ubuntu.
https://forum.ubuntu-it.org/
Codice: Seleziona tutto
Wiphy phy0
Band 1:
Frequencies:
* 2412 MHz [1] (15.0 dBm)
* 2417 MHz [2] (15.0 dBm)
* 2422 MHz [3] (15.0 dBm)
* 2427 MHz [4] (15.0 dBm)
* 2432 MHz [5] (15.0 dBm)
* 2437 MHz [6] (15.0 dBm)
* 2442 MHz [7] (15.0 dBm)
* 2447 MHz [8] (15.0 dBm)
* 2452 MHz [9] (15.0 dBm)
* 2457 MHz [10] (15.0 dBm)
* 2462 MHz [11] (15.0 dBm)
* 2467 MHz [12] (15.0 dBm) (passive scanning, no IBSS)
* 2472 MHz [13] (15.0 dBm) (passive scanning, no IBSS)
Bitrates (non-HT):
* 1.0 Mbps
* 2.0 Mbps (short preamble supported)
* 5.5 Mbps (short preamble supported)
* 11.0 Mbps (short preamble supported)
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
Band 2:
Frequencies:
* 5170 MHz [34] (15.0 dBm) (passive scanning, no IBSS)
* 5180 MHz [36] (15.0 dBm)
* 5190 MHz [38] (15.0 dBm) (passive scanning, no IBSS)
* 5200 MHz [40] (15.0 dBm)
* 5210 MHz [42] (15.0 dBm) (passive scanning, no IBSS)
* 5220 MHz [44] (15.0 dBm)
* 5230 MHz [46] (15.0 dBm) (passive scanning, no IBSS)
* 5240 MHz [48] (15.0 dBm)
* 5260 MHz [52] (15.0 dBm) (passive scanning, no IBSS, radar detection)
* 5280 MHz [56] (15.0 dBm) (passive scanning, no IBSS, radar detection)
* 5300 MHz [60] (15.0 dBm) (passive scanning, no IBSS, radar detection)
* 5320 MHz [64] (15.0 dBm) (passive scanning, no IBSS, radar detection)
* 5500 MHz [100] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5520 MHz [104] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5540 MHz [108] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5560 MHz [112] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5580 MHz [116] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5600 MHz [120] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5620 MHz [124] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5640 MHz [128] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5660 MHz [132] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5680 MHz [136] (16.0 dBm) (passive scanning, no IBSS, radar detection)
* 5700 MHz [140] (16.0 dBm) (passive scanning, no IBSS, radar detection)
Bitrates (non-HT):
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
max # scan SSIDs: 4
max scan IEs length: 2285 bytes
Coverage class: 0 (up to 0m)
Supported Ciphers:
* WEP40 (00-0f-ac:1)
* WEP104 (00-0f-ac:5)
* TKIP (00-0f-ac:2)
* CCMP (00-0f-ac:4)
Available Antennas: TX 0 RX 0
Supported interface modes:
* IBSS
* managed
* monitor
software interface modes (can always be added):
* monitor
interface combinations are not supported
Supported commands:
* new_interface
* set_interface
* new_key
* new_beacon
* new_station
* new_mpath
* set_mesh_params
* set_bss
* authenticate
* associate
* deauthenticate
* disassociate
* join_ibss
* join_mesh
* set_tx_bitrate_mask
* action
* frame_wait_cancel
* set_wiphy_netns
* set_channel
* set_wds_peer
* Unknown command (84)
* Unknown command (87)
* Unknown command (85)
* Unknown command (89)
* Unknown command (92)
* testmode
* connect
* disconnect
Supported TX frame types:
* IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* Unknown mode (10): 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
Supported RX frame types:
* IBSS: 0x40 0xb0 0xc0 0xd0
* managed: 0x40 0xd0
* AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* mesh point: 0xb0 0xc0 0xd0
* P2P-client: 0x40 0xd0
* P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* Unknown mode (10): 0x40 0xd0
Device supports RSN-IBSS.
HT Capability overrides:
* MCS: ff ff ff ff ff ff ff ff ff ff
* maximum A-MSDU length
* supported channel width
* short GI for 40 MHz
* max A-MPDU length exponent
* min MPDU start spacing
Device supports TX status socket option.
Device supports HT-IBSS.
Codice: Seleziona tutto
ii flashplugin-installer 11.2.202.341ubuntu0.13.10.1 i386 Adobe Flash Player plugin installer
gaslucy@gaslucy-Satellite-P100:~$
Codice: Seleziona tutto
sudo lshw -C cpu
Codice: Seleziona tutto
description: CPU
product: Genuine Intel(R) CPU T2300 @ 1.66GHz
vendor: Intel Corp.
physical id: 4
bus info: cpu@0
version: 6.14.8
serial: 0000-06E8-0000-0000-0000-0000
slot: U2E1
size: 1667MHz
capacity: 1667MHz
width: 32 bits
clock: 166MHz
capabilities: boot fpu fpu_exception wp vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca cmov clflush dts acpi mmx fxsr sse sse2 ss ht tm pbe nx constant_tsc arch_perfmon bts aperfmperf pni monitor vmx est tm2 xtpr pdcm dtherm cpufreq
configuration: id=0
*-logicalcpu:0
description: Logical CPU
physical id: 0.1
width: 32 bits
capabilities: logical
*-logicalcpu:1
description: Logical CPU
physical id: 0.2
width: 32 bits
capabilities: logical
*-cpu:1
physical id: 1
bus info: cpu@1
version: 6.14.8
serial: 0000-06E8-0000-0000-0000-0000
size: 1GHz
capacity: 1GHz
capabilities: vmx ht cpufreq
configuration: id=0
*-logicalcpu:0
description: Logical CPU
physical id: 0.1
capabilities: logical
*-logicalcpu:1
description: Logical CPU
physical id: 0.2
capabilities: logical
Sì, facci sapere. Posta anche qualche schermata di pavucontrol. Quali tipi di file audio hai provato?maluq [url=http://forum.ubuntu-it.org/viewtopic.php?p=4548946#p4548946][img]http://forum.ubuntu-it.org/images/icons/icona-cita.gif[/img][/url] ha scritto:Ho installato la 13.10, con le cuffie non ho provato, appena posso provo, ma comunque provo a vedere "alsamixer", poi provo col comando da terminale, vedo un po' e vi faccio sapere. Grazie a tutti