Pagina 1 di 1

usb non si monta

Inviato: domenica 26 aprile 2009, 12:07
da tomallevi
ciao a tutti!!
scusate per questa nuova discussione che certamente sarà già stata aperta da altre 1000 persone, ma non riesco proprio a venirne a capo!!!!
ho una chiavetta usb e vorrei tenere i dati.... ma non riesco a leggerla ne con win che con ubuntu... cm posso fare?!?!
per conpletezza questo sono le ultime righe del dmesg:

Codice: Seleziona tutto

[  936.673204] usb 4-5.1: reset high speed USB device using ehci_hcd and address 7
[  966.841238] usb 4-5.1: reset high speed USB device using ehci_hcd and address 7
[  997.008778] usb 4-5.1: reset high speed USB device using ehci_hcd and address 7
[ 1027.177182] usb 4-5.1: reset high speed USB device using ehci_hcd and address 7
[ 1057.349206] usb 4-5.1: reset high speed USB device using ehci_hcd and address 7
[ 1087.517636] usb 4-5.1: reset high speed USB device using ehci_hcd and address 7
[ 1087.619002] sd 8:0:0:0: [sdf] Result: hostbyte=DID_ABORT driverbyte=DRIVER_OK,SUGGEST_OK
[ 1087.619020] end_request: I/O error, dev sdf, sector 344
[ 1087.619030] __ratelimit: 20 callbacks suppressed
[ 1087.619037] Buffer I/O error on device sdf, logical block 43
[ 1087.619047] Buffer I/O error on device sdf, logical block 44
[ 1087.619056] Buffer I/O error on device sdf, logical block 45
[ 1087.619068] Buffer I/O error on device sdf, logical block 46
[ 1087.619098] Buffer I/O error on device sdf, logical block 47
[ 1087.619106] Buffer I/O error on device sdf, logical block 48
[ 1087.619113] Buffer I/O error on device sdf, logical block 49
[ 1087.619145] Buffer I/O error on device sdf, logical block 50
[ 1087.619152] Buffer I/O error on device sdf, logical block 51
[ 1087.619160] Buffer I/O error on device sdf, logical block 52
[ 1087.643380] sd 8:0:0:0: [sdf] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
[ 1087.643398] sd 8:0:0:0: [sdf] Sense Key : Medium Error [current] 
[ 1087.643408] sd 8:0:0:0: [sdf] Add. Sense: Unrecovered read error
[ 1087.643418] end_request: I/O error, dev sdf, sector 288
[ 1385.675021] usb 4-5: USB disconnect, address 6
[ 1385.675031] usb 4-5.1: USB disconnect, address 7
[ 1390.141053] usb 4-5: new high speed USB device using ehci_hcd and address 8
[ 1390.287078] usb 4-5: configuration #1 chosen from 1 choice
[ 1390.287970] hub 4-5:1.0: USB hub found
[ 1390.288328] hub 4-5:1.0: 1 port detected
[ 1390.568462] usb 4-5.1: new high speed USB device using ehci_hcd and address 9
[ 1390.675370] usb 4-5.1: configuration #1 chosen from 1 choice
[ 1390.676499] scsi9 : SCSI emulation for USB Mass Storage devices
[ 1390.678432] usb-storage: device found at 9
[ 1390.678444] usb-storage: waiting for device to settle before scanning
[ 1395.677057] usb-storage: device scan complete
[ 1395.678670] scsi 9:0:0:0: Direct-Access     LG       USB Drive 2.0    1.00 PQ: 0 ANSI: 0 CCS
[ 1395.682008] sd 9:0:0:0: [sdf] 1015808 512-byte hardware sectors (520 MB)
[ 1395.685129] sd 9:0:0:0: [sdf] Write Protect is off
[ 1395.685141] sd 9:0:0:0: [sdf] Mode Sense: 00 26 00 00
[ 1395.685147] sd 9:0:0:0: [sdf] Assuming drive cache: write through
[ 1395.688134] sd 9:0:0:0: [sdf] 1015808 512-byte hardware sectors (520 MB)
[ 1395.691250] sd 9:0:0:0: [sdf] Write Protect is off
[ 1395.691263] sd 9:0:0:0: [sdf] Mode Sense: 00 26 00 00
[ 1395.691269] sd 9:0:0:0: [sdf] Assuming drive cache: write through
[ 1395.691283]  sdf: sdf1
[ 1395.693990] sd 9:0:0:0: [sdf] Attached SCSI removable disk
[ 1395.695034] sd 9:0:0:0: Attached scsi generic sg6 type 0
[ 1425.952383] usb 4-5.1: reset high speed USB device using ehci_hcd and address 9
[ 1456.121309] usb 4-5.1: reset high speed USB device using ehci_hcd and address 9

cosa c'è di sbagliato?!?!

Re: usb non si monta

Inviato: domenica 26 aprile 2009, 12:31
da steff
prova con testdisk (è nei repo), lancialo (da terminale) e forse può ripararlo.

Re: usb non si monta

Inviato: domenica 26 aprile 2009, 12:46
da tomallevi
non me lo vede...

EDIT: non so cm parte...
lo vede ma ora non so cosa fare.....!!! ;)

Re: usb non si monta

Inviato: domenica 26 aprile 2009, 18:20
da tomallevi
ho provato a fare il log eccolo:

Codice: Seleziona tutto


Sun Apr 26 18:02:18 2009
Command line: TestDisk

TestDisk 6.9, Data Recovery Utility, February 2008
Christophe GRENIER <grenier@cgsecurity.org>
http://www.cgsecurity.org
Linux version (ext2fs lib: 1.41.3, ntfs lib: 10:0:0, reiserfs lib: none, ewf lib: none)
Hard disk list
Disk /dev/sda - 200 GB / 186 GiB - CHS 24321 255 63, sector size=512 - ATA ST3200822AS
Disk /dev/sdf - 520 MB / 496 MiB - CHS 1024 16 62, sector size=512 - LG USB Drive 2.0

Disk /dev/sdf - 520 MB / 496 MiB - LG USB Drive 2.0
Partition table type: None

Analyse Disk /dev/sdf - 520 MB / 496 MiB - CHS 1024 16 62
Current partition structure:
   P Unknown                  0   0  1  1023  15 62    1015808
che significa?!?!

Re: usb non si monta

Inviato: domenica 26 aprile 2009, 23:00
da steff
manca la tabella delle partizioni. Prova con photorec, dalla stessa ditta, di ricuperare i file

Una piccola guida ho scritto qui:
http://www.vogliaditerra.com/vogliadili ... vare-file/

Un 'altra è qui:
http://divilinux.netsons.org/index.php/archives/446

Re: usb non si monta

Inviato: martedì 28 aprile 2009, 20:11
da tomallevi
ma se formattassi la chiavetta USB posso recuperare i dati con testdisk?!?! che ogni tanto la vede e ogni tanto no...

Re: usb non si monta

Inviato: martedì 28 aprile 2009, 21:30
da steff
anche senza formattarla credo

Re: usb non si monta

Inviato: martedì 28 aprile 2009, 21:49
da tomallevi
si ma se non lo formatto non è sicuro che mi veda la USB mentre se è formattato si ;) quindi se formatto recupero i dati con testdisk?!?!

Re: usb non si monta

Inviato: martedì 28 aprile 2009, 21:54
da steff
con photorec, ho fatto una prova e ha funzionato, ovviamente solo formattarlo e non scrivere alcun dato. Ma prova prima se riesci di accedere (anche per formattare devi vederlo)