Forum Ubuntu-it

salute a tutti! premetto che è da poco che traffico con linux...
il problema in poche parole è che non riesco a far funzionare la scheda sul mio pc ho la 9.10
dice che è compatibile con linux e c'è anche una guida ma non so bene che fare..


Linux driver for kernel 2.2.X
 
  The procedure to activate D-Link DFE-528TX 10/100 Adapter
  on linux is as follows:
 
  step 01: Copy the driver source files to a convenient directory.
 
  step 02: Compile
          The instruction for compiling the driver is include at the
          end of the driver file.If a compile-command is not there use
          the following compile command:
          (Run this instruction at /usr/src/linux)
         
          *compile-command:
          " gcc -DMODULE -Wall -Wstrict-prototypes -O6 -c dfe528.c "
           
          Or you can use the Makefile included in the driver disk \LINUX.
 
  step 03: Copy the module "dfe528.o" to
          "/lib/modules/{kernel-version}/net"
 
          *The directory "{kernel-version}" stands for the Linux kernel
            version you use.
 
  step 04: Insert the driver as module:
          insmod dfe528.o
          (Run 'lsmod' to see if the module is inserted)
 
  step 05: Bind your card to an IP address
 
          /sbin/ifconfig eth0 ${IPADDR} broadcast ${BROADCAST}
          netmask ${NETMASK}
          (Run 'netstat -i' to see if there is a interface 'eth0')
 
  step 06: Add your card to IP routing table, then add gateway also
          your card:
          /sbin/route add -net ${NETWORK} netmask ${NETMASK} eth0
          (Should be able to ping local network now)
         
          gateway:
          /sbin/route add default gw ${GATEWAY} netmask 0.0.0.0 metric 1
 
  step 07: Start inet daemon.
          /usr/sbin/inetd
          (You are on the network now)
 
  *make sure that your kernel is built with network, fast_ethernet and
  module support. Otherwise, you have to rebuild your kernel.
  ( 01:Go to /usr/src/linux directory
    02:Run "make menuconfig" or "make config"
    03:Mark the options list above.
    04:Exit and rebuild your kernel.
        make dep;make clean;make zImage
        the file "zImage" will be at
        /usr/src/linux/arch/i386/boot/zImage
    05:Modify /etc/lilo.conf.(this file specify where kernel image is)
    06:Run "lilo" )
 
  You can run "netconfig" which will do step 05,06,07 for you.
 
  Then just add a line at the beginning of "/etc/rc.d/init.d/network".
 
        " insmod /lib/modules/{kernel-version}/net/dfe528.o "
       
        *The directory "{kernel-version}" stands for the Linux kernel
        version you use.
  then your driver will work every time you boot.

aspetto aiuti !

io ho la 9.04 e nemmeno io riesco.