Pagina 1 di 1

Scanner AGFA SnapScan e50

Inviato: sabato 18 settembre 2010, 13:46
da Lor.enzo
Ciao a tutti. Lo scanner in questione non funziona. La versione di ubuntu è la 10.4
Avvio Xsane e il messaggio di errore è Non è possibile aprire il dispositivo 'snapscan:libusb:004:004': si è verificato un errore...
ps: prima era 004:002 , poi è diventato 003 e da quando ho avviato xsane da root è 004.

Nella caretella /usr/share/sane/snapscan è presente il file SnapScan_1212U_2.bin
Questo è cioè che c'è scritto nel file (posto solo le prime righe)

#------------------------------ General -----------------------------------

# Change to the fully qualified filename of your firmware file, if
# firmware upload is needed by the scanner
firmware /usr/share/sane/snapscan/SnapScan_1212U_2.bin

# If not automatically found you may manually specify a device name.

# For USB scanners also specify bus=usb, e.g.
/dev/usb/scanner0 bus=usb

# For SCSI scanners specify the generic device, e.g. /dev/sg0 on Linux.
# /dev/sg0

...
# Agfa Snapscan e42
usb 0x06bd 0x20ff

# Agfa Snapscan e50
usb 0x06bd 0x208f

# Agfa Snapscan e52
usb 0x06bd 0x20fd
...


posto il sudo sane-find-scanner

  # sane-find-scanner will now attempt to detect your scanner. If the
  # result is different from what you expected, first make sure your
  # scanner is powered up and properly connected to your computer.

  # No SCSI scanners found. If you expected something different, make sure that
  # you have loaded a kernel SCSI driver for your SCSI adapter.

found USB scanner (vendor=0x06bd [AGFA], product=0x208f [ Snapscan1212u_2]) at libusb:004:004
  # Your USB scanner was (probably) detected. It may or may not be supported by
  # SANE. Try scanimage -L and read the backend's manpage.

  # Not checking for parallel port scanners.

  # Most Scanners connected to the parallel port or other proprietary ports
  # can't be detected by this program.


E ancora
sala@saladek:~$ sudo scanimage -L
device `snapscan:libusb:004:004' is a AGFA SNAPSCAN 1212U_2 flatbed scanner

Chi mi può aiutare a risolvere il problema?
Nella vecchia versione lo scanner (dopo le procedure necessarie) funzionava. Poi ha smesso di funzionare, ho aggiornato Ubuntu all'ultima versione ed eccomi qua.
Grazie
Lorenzo

Re: Scanner AGFA SnapScan e50

Inviato: martedì 21 settembre 2010, 21:16
da Lor.enzo
Nessuno capace di trovare la soluzione?  ::)