Ho installato da pico Ubuntu 11.04 sul mio pc....sto provando a installare la mia stampante Canon mp160 seguendo la guida
http://wiki.ubuntu-it.org/Hardware/Stam ... PixmaMp160
Funziona tutto....tranne alla fine...quando arrivo a digitare il comando make ottengo questa risposta:
Se poi vado a digitare il comando sudo make install ottengo questo output:make: Nessuna operazione da eseguire per "all".
La stampante viene riconosciuta, ma quando lancio una stampa non succede nulla...Please connect and turn on your scanner! I will try to detect it.
Please wait until your scanner is ready, then press return...read: 39: arg count
Connected scanner(s):
1: Canon PIXMA MP160 (SN:04A91714_8073D2)
I'm about to do a test scan. Please put a magazine or photo in the scanner.
The image will be saved in /tmp/pixmascan.pnm, log file in /tmp/pixmascan.log.
Proceed? [YES/no] YES
Executing: ./scan -x 10 -y 15 -w 51 -h 25 -1 -d 10 -W /tmp/pixmascan.pnm 2> /tmp/pixmascan.log
Connected scanner(s):
1: Canon PIXMA MP160 (SN:04A91714_8073D2)
Scan mode: color
DPI: 75x75
Offset: (32,64) = (1.08cm, 2.17cm)
Dimension: 151x74 = 5.11cm x 2.51cm
Size: 35 kiB (uncompressed, raw)
Source: Flatbed
Scanning...
100% done (35520 bytes written)
Ok, the driver seems to work with your scanner.
Please check /tmp/pixmascan.pnm if it shows a small picture.
Install the stand-alone program in '/usr/local/bin'? [YES/no] YES
The stand-alone programm was successfully installed at
/usr/local/bin/pixmascan
SANE backend directory: NOT FOUND!
SANE dll.conf: /etc/sane.d/dll.conf
Unable to find SANE backend directory and dll.conf!
Have you already installed the SANE package?
Basic installation completed.
NOTE: You probably need to set the permission of the device node in
/dev/bus/usb or /proc/bus/usb. See the manual of your OS.
For Linux, see http://www.sane-project.org/README.linux
Qualcuno può darmi una mano? >:(
Grazie in anticipo