Forum Ubuntu-it

ho installato l ultima versione di kubunto,non riesco ad attivare la scheda citata,vorrei sapere come muovermi ed eventualmente che controlli effettuare con cavo eth navigo tranquillamente

ciao e grazie

posta

1°


-network             
      description: Ethernet interface
      product: 82562GT 10/100 Network Connection
      vendor: Intel Corporation
      physical id: 19
      bus info: pci@0000:00:19.0
      logical name: eth0
      version: 03
      serial: 00:1a:4b:92:f1:fb
      size: 100Mbit/s
      capacity: 100Mbit/s
      width: 32 bits
      clock: 33MHz
      capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd autonegotiation
      configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=1.3.10-k2 duplex=full firmware=1.1-2 ip=192.168.1.103 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
      resources: irq:45 memory:dc500000-dc51ffff memory:dc520000-dc520fff ioport:5000(size=32)
  *-network
      description: Network controller
      product: BCM4311 802.11b/g WLAN
      vendor: Broadcom Corporation
      physical id: 0
      bus info: pci@0000:10:00.0
      version: 02
      width: 64 bits
      clock: 33MHz
      capabilities: pm msi pciexpress bus_master cap_list
      configuration: driver=b43-pci-bridge latency=0
      resources: irq:17 memory:dc000000-dc003fff
  *-network DISABLED
      description: Wireless interface
      physical id: 2
      logical name: wlan0
      serial: 00:1a:73:e6:69:21
      capabilities: ethernet physical wireless
      configuration: broadcast=yes driver=b43 driverversion=3.0.0-12-generic firmware=N/A link=no multicast=yes wireless=IEEE 802.11bg


iwconfig:

lo        no wireless extensions.

eth0      no wireless extensions.

wlan0    IEEE 802.11bg  ESSID:off/any 
          Mode:Managed  Access Point: Not-Associated  Tx-Power=0 dBm 
          Retry  long limit:7  RTS thr:off  Fragment thr:off
          Power Management:on

dovresti  avere i driver b43 da abilitare sotto  impostazioni di sistema-driver aggiuntivi.

grazie mille ora funziona tutto