Stavo cercando di configurare la velocità delle ventole per vedere se su lucid avrebbe funzionato ma mi fermo prima poichè al momento di configurare il tutto
succede che:
Codice: Seleziona tutto
paulaner@ciompizzz:~$ sudo pwmconfig
[sudo] password for paulaner:
# pwmconfig revision 5770 (2009-09-16)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.
We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.
/usr/sbin/pwmconfig: There are no pwm-capable sensor modules installed
paulaner@ciompizzz:~$ dmesg | grep it87
[ 10.489137] it87: Found IT8716F chip at 0xe80, revision 3
[ 10.489148] it87: in3 is VCC (+5V)
[ 10.489177] ACPI: I/O resource it87 [0xe85-0xe86] conflicts with ACPI region HWRE [0xe85-0xe86]Il fatto strano è che in precedenza ( 9.10 ) quando era attivo il "QFAN CONTROL" nel BIOS non riuscivo a leggere la velocità delle ventole mentre ora sì
In ogni caso ora non ho attivo nessun controllo delle ventole nel BIOS.
Allego il dmesg:
