Ho appena installato ubuntu 10.10 x64 sul mio HP G61, tutto ok se non fosse per il wifi.
il computer è dotato di uno switcher on/off per l'attivazione del wireless (perfettamente funzionante in windows), che purtroppo non vuole saperne di attivarsi, cosa che (tra l'altro) accadeva anche con Ubuntu Studio 10.04. Alla pressione del tasto, infatti, la luce "on" rimane accesa per un solo secondo e poi si spegne di nuovo, attualmente navigo in tethering usb con il mio telefono. La scheda wireless è un modello Atheros.
iw config
iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=off
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
easytether0 no wireless extensions.
ifconfig
ifconfig
easytether0 Link encap:Ethernet HWaddr 02:00:54:74:68:72
inet addr:192.168.117.2 Bcast:192.168.117.255 Mask:255.255.255.0
inet6 addr: fe80::54ff:fe74:6872/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1559 errors:0 dropped:0 overruns:0 frame:0
TX packets:1465 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:500
RX bytes:1345374 (1.3 MB) TX bytes:273682 (273.6 KB)
eth0 Link encap:Ethernet HWaddr c8:0a:a9:60:5f:13
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:43 Base address:0x8000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:140 errors:0 dropped:0 overruns:0 frame:0
TX packets:140 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10992 (10.9 KB) TX bytes:10992 (10.9 KB)
Ringrazio tutti in anticipo!


metti risolto al tuo primo mesaggio


