Configurare Wi Fi per la stampante MP495

[AntonioLecce]

Qualcuno che c'è già passato saprebbe darmi una mano?! con usb stampa e scannerizza. ....con wifi non so da dove iniziare...

[AntonioLecce]

Sto cercando di seguire un post di un forum che mi è stato utile per l'installazione dei driver

Codice: Seleziona tutto

For setting your MP495 printer up on your network without the use of a Windows or Mac machine (Fresh out of the box with Ubuntu) you will need to match your Routers SSID to the printers default SSID, and remove any security you have enabled. This will allow the printer to connect to your network.
Printer Defaults:
SSID: BJNPSETUP
IP ADDRESS: Automatic

Once you have done that you will need to activate the wireless lan on the printer.
Press the Maintenance button on the printer 13 times until you see what looks like a capital G without the middle line. Then press the color start button. (refer to page 10 of your Network Setup Troubleshooting manual for an actual picture of the symbol) You should see the wifi light on the front of the printer turn on and be solid not be blinking. (If it is blinking check your routers SSID settings and match the Default SSID of the printer as listed above.

Now download angryipscanner AngryIPScanner and install it by double clicking it. It should open in the Software center or with the Gdebi installer. (this may take a few minutes to install.)
Once you have installed AngryIPScanner, run it and change the ip range to include from 1 - 254 in the last octet. Then click start.
When it finishes look for an active connection with a Hostname like A001BF000000.local. Yours may be different but should be very simular.
The IP address given for that hostname is the IP address of your printer. Open Firefox and type that address in the address bar and press enter. From there you can configure you printer for the SSID, and encryption that you had on your router before the change, and set a static IP for the printer so you can manage it easily.
After you change the SSID and encryption on the printer you will have to go back to your router and change the SSID and encryption back to what it was before so your printer can connect again.

Now your network should be back the way it was and your printer should be connected

Dovrei aver fatto tutto,ma una volta installato AngryIpScan mi trovo solo il mio di ip!!
Alchè mi chiedo se il problema sia nella parte iniziale,nell' SSID.  Difatti non è una parte che capisco moltissimo. Dunque, quello che ho fatto è andare sulla pagina del mio router FastWeb e cambiare il nome dell' SSID in BJNPSETUP...giusto?!!?  per l'ip automatico onestamente non so come fare, e non ho toccato nulla!! cmq...pur rinominndo la mia connessione come scritto sopra non funziona nulla!! qualcuno che può aiutarmi?!?!

[AntonioLecce]